Using a text editor, remove the text indicated in bold to both files, so that it reads as follows:.Navigate to SEPMInstall\apache\conf\ssl.Configure Windows XP / Server 2003 to use TLS 1.0 Note: Windows XP / Server 2003 does not support TLS 1.1 or higher and must use TLS 1.0. The client computers should now check in and begin to communicate with TLS 1.2 only. Symantec Endpoint Protection Manager Webserver.Symantec Endpoint Protection Manager API Service. Restart the following management server services:.NOTE: In SEPM 14.3 RU2 and later ssl.conf is configured to use TLS 1.2 by default and does not require editing. SSLProtocol all -SSLv2 -SSLv3 -TLSv1 -TLSv1.1 Using a text editor, edit the lines in ssl.conf and nf above and add the text indicated in bold below to both files, so that it reads as follows:.In the files ssl.conf (for port 8445) and nf (for port 443), locate the following line in each:.After you log on to the SEPM, navigate to SEPMInstall\apache\conf\ssl.The time that is needed varies depends on the mode and the length of the heartbeat. Allow the clients time to check in with the management server and move to the new group.See Moving a client computer to another group. Move the clients that run an unsupported operating system into this group.See Assigning a management server list to a group and location. Assign this management server list to this group.Add this server’s address, and click OK to save.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |